Mapping

Options
Jasmine1
Jasmine1 Member, ALL USERS Posts: 1 New Contributor
in Anaplan Community

Hi guys, so I’ve been struggling on some of the mapping activities. I’ve tried everything over the past 2 days and I️ can’t seem to figure it out. Specifically activity 4.6.7. If you all have any tips that helped you all figured it out I would greatly appreciate it. 

Comments

  • Nikole18
    Nikole18 Member, ALL USERS Posts: 5 Occasional Contributor

    Me too I’m very confused 

  • AndreRico
    AndreRico Member, ALL USERS Posts: 2 New Contributor
    Try to delete the master data (List) P2 Product and go back to the lesson that creates it. Maybe you missed some point. I did this lesson with no problems.
  • Ruthkirui
    Ruthkirui Member, ALL USERS Posts: 1 New Contributor
    If it helps, open the csv file that you're importing. I found this was helpful in understanding the data. Looking at the final result on the coursework also helps.
  • JudyWM
    JudyWM Member, ALL USERS Posts: 5 New Contributor

    Okay how should I map activity 4.6.6? I think that is where I’m going wrong. And then how do I map activity 4.6.7?

  • JudyWM
    JudyWM Member, ALL USERS Posts: 5 New Contributor

    I tried your mapping. although I noticed the grid view is not similar to the example using your mapping.  here is a screen shot of what else I tried. My P1 got to look like in the lesson but once I get to p2 then I get errors 

    P1 mapping 

    JudyWM_0-1633872194370.png

    JudyWM_1-1633872231386.png

     

  • JudyWM
    JudyWM Member, ALL USERS Posts: 5 New Contributor

    here is my step by step screenshots of me doing it your way

    JudyWM_1-1633875687220.png

    here it is in Grid View... maybe I entered the General list and hierarchy wrong 

    JudyWM_2-1633875770664.png

    and here is what P2 looks like doing it the same way you told me. 

    JudyWM_3-1633875915154.png

    and i get this error

    JudyWM_4-1633875949482.png

     

    and my Grid View for P2

    JudyWM_5-1633875979219.png

     

  • Chwayitea
    Chwayitea Member, ALL USERS Posts: 5 Contributor

    P2 I selected code only while mapping

  • Chwayitea
    Chwayitea Member, ALL USERS Posts: 5 Contributor

    The other way, delete everything on P2, manually enter the codes on P1 then import P2 again after this step. Do you have Teamsview?

Categories