Importing File No Error but Zero Created Cells

Options
jmroesser
jmroesser Member, ALL USERS, Partner, Community Member, Certified Model Builder Posts: 5 Occasional Contributor
in Extensibility

Hello Anaplan Community! I had an issue a few days ago where I imported a data file and everything looked good on importing, no errors were generated but no cells were actually created. When I checked the flat list, there was nothing imported into the list. The excel file was in CSV format and everything was properly updated in excel. Is there a particular reason why Anaplan would show everything is ok but nothing is actually imported? Thank you!

Tagged:

Comments

  • chetirski
    chetirski Member, ALL USERS, Partner, Certified Master Anaplanner, Certified Model Builder Posts: 5 Certified Master Anaplanner

    Hi, 
    Did you check the mapping of the action during the set-up?

    It might be that nothing was mapped, so nothing was created.
    I am not sure if this would show as an issue during the action execution, but still worth checking.

  • jmroesser
    jmroesser Member, ALL USERS, Partner, Community Member, Certified Model Builder Posts: 5 Occasional Contributor

    Thank you for the response! Yes I did, about 99% sure it was mapped correctly. Is this the only potential problem or are there others?

  • jmroesser
    jmroesser Member, ALL USERS, Partner, Community Member, Certified Model Builder Posts: 5 Occasional Contributor

    @ashish.banka  It was entered into a flat list if that helps at all. Tried it again and got the same message, everything was good but 0s on all categories.

Categories