8.2.3 Formatting Error

Options
shady10
shady10 Member, ALL USERS Posts: 5 Occasional Contributor
in Anaplan Community

For REV03 Margin Calculation Module the formatting instructions say 0 decimals however, in the final screenshot there are 2 decimals in the output. Is this an error?

shady10_0-1639065960504.png

 

Comments

  • ngangas
    ngangas Member, ALL USERS Posts: 1 New Contributor
    I noticed that too and I would say yes. I just changed it to 2 decimals to match the screenshot
  • MHaygood
    MHaygood Member, ALL USERS Posts: 1 New Contributor

    Hello, 

     

    It was the same thing for me then after other changes I went back and it was the correct way. 

Categories